| Repair
Beam Ends We
can manufacture steel shoes to exactly fit your existing beams to replace weak
or missing bearing ends . We
design and manufacture to your exact requirements the following parts; 1.
Joist end plates - standard and special pairs of L section plates with coach screws 2.
Joist splice plates - standard and special pairs of L section plates with self
piercing screws and bolt sets 3.
Structural Beam Shoes - made to measure twin plate or channel U shaped plates,
with bolt sets 4. Timber-Resin
Repair Kits - made to measure, high tensile steel bars bonded into new timber
ends, with pouring or injection resins.
  
Joist
End Repair Plates - steel galvanised or Joist Splice Plates - alloy treadplate.
For full end replacement - Timber-Resin Splice Kits.
Repair
Roof Timber Joints We
supply plates and fixings for joints that have split or opened up. 1.
Plates - steel, cut to shape and drilled for bolts, to reinforce joints, in pairs 2.
Angle Iron - steel, to reinforce the upper and lower edges of split or weakened
timbers, drilled for coach screws or bolts 3.
Dowels - high tensile steel allthread, supplied with plate washers and nuts, for
connections to plates 4.
Dowels in Epoxy Resin - High Tensile Steel, Epoxy-Glass, Spiral or twisted stainless
bars for setting into Thixotropic Epoxy Injection resin.
Load
Spread with X or S Plates - Patress Plates We
supply X or S shaped plates of any size with fixings to re-connect or restrain
walls and beams. 1.
Through connecting tie rod - supplied with high tensile threaded bars and couplers,
to connect large X or S plates via a central hole 2.
Reinforcement fixing - for bolting through to a matching X or S plate with bolts,
nuts and washers. 3. Bonded
in - connecting rods to pass into floor joists as lateral ties, which are bonded
into masonry with Thixotropic Epoxy Injection resin.
Steel
Bars in Resin We
supply high tensile zinc plated or stainless steel allthread to act in tension
and bending within resin repairs. We
offer an extensive range of Timber repair options for Churches and Historic Buildings
in order to avoid removal of structural timber. In
many cases timbers can be repaired in-situ, from inside the building.
    
Holes
drilled ready for bars. Beam Upgrade - bars bonded into Epoxy. Steel Bars in a
shutter box. Epoxy resin Injection Kit - 400cc. Repair
Sections - new pieces of kiln dried, Strength Graded timber made to fit the
damaged area, bonded in with epoxy Cast
In-Situ Resins - Structural Epoxy Pouring resin and Injection Resins for rebuilding
sections, using 'shuttering', where there is no access for a repair section to
be introduced. Boron
Treatments - kill Dry Rot, Wet Rot and Woodworm inside the existing timber
with Boron-based preservatives. Liquids, pastes, gels and solid rods of Borate
all contribute to a long service life for damp timbers
Free
Advice Speak
directly to a real person about your Steel Fabrication needs: 01626 331351
| 